Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Q-Control Install & Hookup Instructions
#2
after flashing the 8266, i reboot, and connect to the ap, but it is asking me for login and pw, this isnt in the documentation? it is same if i use setup.com or 192.......

(07-09-2017, 01:23 AM)mlogsdon Wrote: after flashing the 8266, i reboot, and connect to the ap, but it is asking me for login and pw, this isnt in the documentation? it is same if i use setup.com or 192.......

Reflashed using default settings of flash exe, will see if that works, when reflashing
Soldered a new esp..and when logging in on network, have the same issue with password and log in. I used the default login Admin, and didnt insert password, After rebooting and hooking up AVR my network see's it, gave it a static ip, but when going to log in, the password thing comes up again? As a side not, if using infinity, change seeting in gateway for zero config, under advance to be able to access device
Reply


Messages In This Thread
RE: Q-Control Install & Hookup Instructions - by mlogsdon - 07-09-2017, 01:23 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)