Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Q-Control Build w/MicroDamper
#6
Diagram seems ok, can't determine if the mosfet is wired correctly (S/D/G lines are not labelled on mosfet)BUT... there's always a BUT, I just looked at the MicroDamper and there are some thoughts/issues...

The MicroDamper only has 4 connections, really you need 5, (3 for servo) (2 for fan). He got away with sharing the ground with fan/servo.....BUT that's because the HM uses a more complex fan control that controls the + line (not the 'normal' negative/ground like the N mosfet fan hookup does). So in our hookup you can't share grounds....

However, looking at your diagram, if you are planning to use 5v fan then that should work as you are sending separate grounds to the MicroDamper....and sharing the +5v between fan/servo. Im no expert but that should work...you'll just have to make sure your MicroDamper cable is wired properly.

If you are using a 12v fan, then it would require something totally different, or I'd suggest not using the MicroDamper and use the Other types of Damper/Fans that pass all 5 lines via cable....
Reply


Messages In This Thread
Q-Control Build w/MicroDamper - by JohnW - 04-07-2017, 01:33 PM
RE: Q-Control Build w/MicroDamper - by NailBuster - 04-09-2017, 04:37 PM
RE: Q-Control Build w/MicroDamper - by JohnW - 04-09-2017, 11:23 PM
RE: Q-Control Build w/MicroDamper - by NailBuster - 04-10-2017, 12:22 AM
RE: Q-Control Build w/MicroDamper - by JohnW - 04-12-2017, 01:50 PM
RE: Q-Control Build w/MicroDamper - by NailBuster - 04-12-2017, 02:20 PM
RE: Q-Control Build w/MicroDamper - by JohnW - 04-12-2017, 03:20 PM
RE: Q-Control Build w/MicroDamper - by NailBuster - 04-12-2017, 03:37 PM
RE: Q-Control Build w/MicroDamper - by NailBuster - 05-27-2017, 02:54 PM
RE: Q-Control Build w/MicroDamper - by JohnW - 06-18-2017, 03:01 AM
RE: Q-Control Build w/MicroDamper - by NailBuster - 06-18-2017, 03:30 AM
RE: Q-Control Build w/MicroDamper - by JohnW - 12-19-2017, 08:58 PM
RE: All-In-One Mini Q-Control Unit - by JohnW - 04-07-2017, 04:01 PM
RE: All-In-One Mini Q-Control Unit - by JohnW - 04-09-2017, 04:04 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)