Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Q-Control Build w/MicroDamper
#7
Thanks David for starting a new threat for me.

I confirmed with SteveCK that the 5v fan fits and as well works, he has other users who are using the 5v fan with their smokers with good success.

On the wiring, yes I am sharing the +5v line for both the servo and fan and then bringing back separate grounds.  That makes 3 wires.  Then 1 wire for the servo signal line, that makes 4 total wires.  Sounds right?!?!?

Is it OK to share the power line for the servo since the diode is attached to it?
For the mosfet I checked to see which leg was which and wired appropriately.
Is the diode in the correct orientation? Was not sure which side the stipe should be on.

Thanks for the feedback, once i have all the parts I'll assemble and post more pics.
Reply


Messages In This Thread
Q-Control Build w/MicroDamper - by JohnW - 04-07-2017, 01:33 PM
RE: Q-Control Build w/MicroDamper - by NailBuster - 04-09-2017, 04:37 PM
RE: Q-Control Build w/MicroDamper - by JohnW - 04-09-2017, 11:23 PM
RE: Q-Control Build w/MicroDamper - by NailBuster - 04-10-2017, 12:22 AM
RE: Q-Control Build w/MicroDamper - by JohnW - 04-12-2017, 01:50 PM
RE: Q-Control Build w/MicroDamper - by NailBuster - 04-12-2017, 02:20 PM
RE: Q-Control Build w/MicroDamper - by JohnW - 04-12-2017, 03:20 PM
RE: Q-Control Build w/MicroDamper - by NailBuster - 04-12-2017, 03:37 PM
RE: Q-Control Build w/MicroDamper - by NailBuster - 05-27-2017, 02:54 PM
RE: Q-Control Build w/MicroDamper - by JohnW - 06-18-2017, 03:01 AM
RE: Q-Control Build w/MicroDamper - by NailBuster - 06-18-2017, 03:30 AM
RE: Q-Control Build w/MicroDamper - by JohnW - 12-19-2017, 08:58 PM
RE: All-In-One Mini Q-Control Unit - by JohnW - 04-07-2017, 04:01 PM
RE: All-In-One Mini Q-Control Unit - by JohnW - 04-09-2017, 04:04 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)