Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Q-Control Build w/MicroDamper
#8
that should work fine then with a 5v.

IMO,  I'd put the diode (white stripe to +)  on the connector inside the microdamper if it fits.  The closer the diode to the motor the better... also it may help better there as the 5v for the servo is there as well.  The diode is there to protect back EMF from the motor as it spins down.  Here's what I did for the RAMPS connector

BTW:  I looked at your image again...  you are connecting the rx/tx pins incorrectly.  look at the hookup diagram...the rx/tx from atmega go to d1/d2.... same with the RST... your hookup won't work that way.

keep us posted....
Reply


Messages In This Thread
Q-Control Build w/MicroDamper - by JohnW - 04-07-2017, 01:33 PM
RE: Q-Control Build w/MicroDamper - by NailBuster - 04-09-2017, 04:37 PM
RE: Q-Control Build w/MicroDamper - by JohnW - 04-09-2017, 11:23 PM
RE: Q-Control Build w/MicroDamper - by NailBuster - 04-10-2017, 12:22 AM
RE: Q-Control Build w/MicroDamper - by JohnW - 04-12-2017, 01:50 PM
RE: Q-Control Build w/MicroDamper - by NailBuster - 04-12-2017, 02:20 PM
RE: Q-Control Build w/MicroDamper - by JohnW - 04-12-2017, 03:20 PM
RE: Q-Control Build w/MicroDamper - by NailBuster - 04-12-2017, 03:37 PM
RE: Q-Control Build w/MicroDamper - by NailBuster - 05-27-2017, 02:54 PM
RE: Q-Control Build w/MicroDamper - by JohnW - 06-18-2017, 03:01 AM
RE: Q-Control Build w/MicroDamper - by NailBuster - 06-18-2017, 03:30 AM
RE: Q-Control Build w/MicroDamper - by JohnW - 12-19-2017, 08:58 PM
RE: All-In-One Mini Q-Control Unit - by JohnW - 04-07-2017, 04:01 PM
RE: All-In-One Mini Q-Control Unit - by JohnW - 04-09-2017, 04:04 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)