Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Q-Control Build w/MicroDamper
#11
Apologies David, I'm still a n00b with electronics.

I went on Thingverse just now and see that the MG90 fits as well.  And I can see why when checking specs on the servos, see this link.  

The SG90 & MG90 are the same dimensions and both are analog, the only difference I can see is one has plastic gears (SG) and the other has metal gears (MG).  However the MG90S is slightly smaller (per the link I provided) and I'll check with Steve to see if that will be an issue (as in 'too loose' in the housing).

~~~~~~
Analog vs Digital:
I found this article, which is referenced on several sites, states "The difference between the two is in how the signal from the receiver is processed and how this information is used to send power to the servo motor."

So you are correct in that the difference between digital vs analog servos are the servo's internal electronics. And if I understand the rest of the article correctly, it does not matter if you use an analog or digital pin with an analog or digital servo.  That is where I was getting confused and now understand better.


Again, I'm still a n00b Huh  with electronics, so forgive my ignorance.  I'm slowly but surely learning  Big Grin and appreciate your patience.
Reply


Messages In This Thread
Q-Control Build w/MicroDamper - by JohnW - 04-07-2017, 01:33 PM
RE: Q-Control Build w/MicroDamper - by NailBuster - 04-09-2017, 04:37 PM
RE: Q-Control Build w/MicroDamper - by JohnW - 04-09-2017, 11:23 PM
RE: Q-Control Build w/MicroDamper - by NailBuster - 04-10-2017, 12:22 AM
RE: Q-Control Build w/MicroDamper - by JohnW - 04-12-2017, 01:50 PM
RE: Q-Control Build w/MicroDamper - by NailBuster - 04-12-2017, 02:20 PM
RE: Q-Control Build w/MicroDamper - by JohnW - 04-12-2017, 03:20 PM
RE: Q-Control Build w/MicroDamper - by NailBuster - 04-12-2017, 03:37 PM
RE: Q-Control Build w/MicroDamper - by NailBuster - 05-27-2017, 02:54 PM
RE: Q-Control Build w/MicroDamper - by JohnW - 06-18-2017, 03:01 AM
RE: Q-Control Build w/MicroDamper - by NailBuster - 06-18-2017, 03:30 AM
RE: Q-Control Build w/MicroDamper - by JohnW - 12-19-2017, 08:58 PM
RE: All-In-One Mini Q-Control Unit - by JohnW - 04-07-2017, 04:01 PM
RE: All-In-One Mini Q-Control Unit - by JohnW - 04-09-2017, 04:04 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)